If The Real Ghostbusters capture a ghost while driving to a call or back to The Fire House they can use Ecto-1A’s ghost claw to “grab” the ghost (included) and reel it in. If it were the same car it would most likely still have the ECTO 1 plate. Toy Fact: The gunner seat can be stored inside Ecto-1A for “undercover work.”Įcto 1A Fact: Although the events that took place during Ghostbusters II are acknowledged in the episode Partners In Slime, The Real Ghostbusters never converted Ecto-1 into Ecto-1A. The Ecto 1A (officially named Ecto-1a) was an updated version of the Ecto-1 that the Ghostbusters used to travel. The biggest most in plain sight proof that its a different car, is the license plates. The roof mounted swivel seat that takes its place (called a gunner seat) has GhostBlasters that rotate from the attached seat. Probably because of lack of space and for more fun, Ecto-1A doesn’t have the roof mounted proton cannon that’s seen in the movie and on the cartoon Ecto-1. Note: Since Ecto-1A is built the same as Ecto-1, part of the write up is taken from my Ecto-1 write up.Įcto-1A‘s front doors and rear door open (downward like a ramp) to enter and exit the car. Since then other companies have made more accurate Ecto-1A toys. Poltergeists are mischievous spirits that are often seen in groups and are often capable of escaping sight. In general, Poltergeists are a type of ghost that enjoy causing confusion and chaos. They can be minions of more powerful ghosts or entities. Placula and Blastaea hypothesis in the first drawings Figure 2 (1ad). Poltergeists are a type of creature that are most known for causing mischief. Once a kid and/or older cousin open the box, they might be disappointed that without decals, this is the same exact Ecto-1 as the original. The decals are what turn Ecto-1 into Ecto 1A. differentiate into ecto- and entoderm cells (intrasomatic differentiation). Big words to come, it would have been most likely cost prohibited. I’m not positive, by 1990 I don’t think Kenner was still printing the Ecto-1 box graphics to sell both Ecto-1s. A small detail is the note for a windswept Slimer as a hood ornament. After Ghostbusters II Kenner slightly retooled (used loosely) the original ECTO-1 they sold so they could sell it as ECTO-1A.įirst thing we visibly notice is the new Ecto-1A box graphics. The late Stephen Dane’s isometric design drawing for the Ecto-1a of Ghostbusters II (1989).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |